Epson MR Series Technical Reference Manual page 70

Setup procedure
Windows 2000 is set up by using the following procedure:
1. Connect the keyboard and mouse to the IM-800.
2. Insert the CD-ROM of Windows 2000 in the CD-ROM drive and boot up the system.
3. The Setup Wizard starts, and the Welcome dialog box is displayed. Select [Install a new copy
of Windows 2000], and then click Next.
4. The License Agreement is displayed. Read it through and confirm your agreement to the
terms. And then select [I accept the agreement] and click Next.
5. The Your Product Key screen is displayed. Input the 25-digit product key shown on the
COA (Certificate of Authenticity). Click Next to begin setup.
6. Input the necessary information and continue the installation according to the instruction on
the screen.
7. When copy of the file is completed, reboot the system again according to the instruction on
the screen.
8. After rebooting the system, continue the installation according to the instruction on the
screen.
9. Reboot the system again according to the instruction on the screen.
10. After the system setting is automatically updated, input the necessary information and
continue the installation according to the instruction of the screen.
11. The installation is completed, then click Finish according to the instruction on the screen.
12. After the system is rebooted, the Network Identification wizard is started. Click Next.
13. Set the Password according to the instruction on the screen.
14. The installation is completed, and the desktop screen of Windows 2000 is displayed.
CAUTION:
Setup is executed with the VGA display.
Note
By default, it is impossible to recover from the standby mode with touch panel, keyboard and PS/2 mouse.
Follow the steps below to set the power management.
1. Open Start-Settings-Control Panel.
2. Double-click System in the Control Panel.
4-20 OS and Drivers Rev. I