Epson MR Series Technical Reference Manual page 134

TK3ES=string:
TKJSS=string:
TKJES=string:
BEEP=ON:
BEEP=OFF:
MSR=m...:
KEYTBL=pathname:
/TRACE:
/TRON:
/TROFF:
/VAL=xxh, yyh:
/PARA[zzh]:
/CODE[zzh]:
/DATA:
/KB128=ON:
/KB128=OFF:
Although there are Other parameters such as "KeyLock", "/KEY=xxh,yyh,zzh", "MSR1", and
"MSR3", their use is prohibited in the DM-820 MSR unit.
4-84 OS and Drivers
Replaces the 3track end flag of the MSR with the string. The default is
"?."
Replaces the JIS II type start flag of the MSR with the string. The default
is " " (20th).
Replaces the JIS II type end flag of the MSR with the string. The default
is "%" (7th).
Enables the buzzer sound when the magnetic card is read. This is the
default setting. When the magnetic card is read in order, the buzzer
sounds once. When an error is caused to the magnetic card reading, the
buzzer sounds three times. The LED lights up at the same time.
Invalidates the sound loaded from the card with the MSR123 and only
illuminates the LED.
Specifies the track that enables the MSR decode. The following four
characters can be specified:
"1": ISO/JIS1 type Track 1
"2": ISO/JIS1 type Track 2
"3": ISO/JIS1 type Track 3
When the same character is specified more than once, an error is caused.
The default is "123". "MSR1" is "MSR=12," and "MSR3" is "MSR=23."
Sets the scan code conversion table for converting the MSR data into the
scan code. This is used for any keyboard other than the U.S. 101-key
keyboard and the Japan 106-key keyboard.
Displays the trace information to the standard output. For example, this
can be saved in a file by using the redirect.
Enables the trace function.
Disables the trace function (default value).
Sets variable xxh to the yyh address of the system.
Displays the values of the system variables from 00h to FFh. When zzh is
specified, the SRAM values from zz00h to zzFFh are displayed.
Displays the content of the Flash ROM in which the firmware codes are
written.
Displays zz00h-zzFFh when [zzh] is indicated, and 4000h-40FFh when it
is omitted.
Displays the contents of the firmware's internal RAM.
When used in combination with KB128 (Programmable keyboard by
GIGA), this setting is assumed when the LED status display differs from
the actual input in simultaneous input with an external keyboard.
Set when the above is released. This setting is the initial value.
Rev. I