Connector Cables For A Dm-M820 With No Touch Panel And No Msr; Connecting The Power Cable For Ac Adapter; Im-800 Connectors - Epson MR Series Technical Reference Manual

Note:
If you are using a DM-M820 with a touch panel, be sure to connect the serial port connector to
COM1 or COM2. Do not use COM3 or COM4.
Also if you are using a DM-M820 with a touch panel, do not install a mouse driver. Installing a
mouse driver can prevent the touch panel from working.

Connector Cables for a DM-M820 with No Touch Panel and No MSR

❏ DC plug
❏ Display connector

Connecting the Power Cable for AC Adapter

Be sure to push the end of the power cable all the way into the AC inlet. The fitting on the power
cable should make contact with the back of the inlet.
CAUTION:
Do not use the DC plug on a system other than the IM-800 or the OI-MR01 (AC adapter).
The DC plug on the exclusive cable is designed only for the IM-800 or the OI-MR01 (AC
adapter).

IM-800 Connectors

The illustration below shows all the connectors on the back of the IM-800. In addition, there are
two USB connectors on the front. (See Chapter 1.)
Be sure to unplug the power cable from the IM-800 before you connect these cables.
Standard model
Mouse
Keyboard
2-4 Setup for the IM-800 and the DM-M820
Connect to the 12 VDC output of the IM-800 or AC adapter
(OI-MR01).
Connect to the display port of the IM-800 or PC.
COM2
Display
COM1
LPT Ethernet
PCI slot COM3
Line-out Line-in Mic input
USB
12 VDC output
for DM-M820
AC Inlet
COM4
Rev. I