Installing The Dm-M820; Cable Arrangement - Epson MR Series Technical Reference Manual

If the IM-800 is placed horizontally with the rear cover installed, attach the rubber feet
that are included or leave at least 1 cm {0.4"} of space from the bottom of the rear
cover.
Do not put anything that weighs more than 20 kg {44 lb} on the IM-800 when it is installed
horizontally.

Installing the DM-M820

Cable Arrangement

When you plan your installation of the DM-M820, consider the cable that comes out of the base.
There are two ways you can arrange the cable:
❏ Make a hole in the surface on which you will place the unit and run the cable through the
hole (A in the illustration below).
❏ Remove the tab from the back of the LCD stand and run the cable out of the back of the LCD
stand (B in the illustration below).
A
CAUTION:
If burrs are left after the tabs are removed, they may cause cuts or scratches. Remove
the burrs with a nipper or file.
2-2 Setup for the IM-800 and the DM-M820
Installing face
1cm or more
B
Rev. I