Removing The Front Case - Epson MR Series Technical Reference Manual

Removing the Front Case

1. Remove the rear case.(See page 9-11.)
2. Remove 2 screws (S15) securing the LCD assembly to the front case. After then remove 2
screws (S05) holding 2 ground wires (one on each side) and lift up the ground wires. (The
model with a touch panel is used in the illustration below.)
screw (S15)
front case
screw (S05)
Note:
The ground wires are not attached to the model without a touch panel.
3. Remove the front panel unit holding LCD assembly from the front case. (See the
illustration above.)
To install, reverse the removal procedure.
CAUTION:
To avoid damage during reassembly, do not apply pressure to any circuit boards when
you fasten them in place.
9-12 Disassembly and Assembly
screw (S05 ) and ground wire
screw (S05 ) and ground wire
screw (S15)
front panel unit holding
LCD assembly
cable shown in top photo
Rev. I