Epson MR Series Technical Reference Manual page 235

6. Remove the screws (S05) securing the touch panel assembly to the front panel unit. Then
remove the touch panel assembly by lifting up it.
touch panel
screws (S05)
Note:
Lift up the touch panel assembly carefully. Otherwise, the double-coated electric-conductive tape attached
to each plate and the LCD unit will come off incorrectly.
When reattaching the touch panel assembly, align the position of the holes in the touch panel assembly and
the front panel unit. Otherwise, the plates may be attached to the front panel unit incorrectly with the
double-coated electric-conductive tape. Then you cannot reuse the same tape after you realign the screw
holes.
To install, reverse the removal procedure.
If you reattach the touch panel assembly (1056), follow the steps below.
1. Place the touch panel assembly on the front panel unit to align the position of the each screw
holes.
2. Then attach the touch panel assembly to the front panel unit with the 4 screws (S05).
When you replace the touch panel assembly itself, follow the steps below for reassembly:
Rev. I
front panel unit
position of the screw holes
MR Series Technical Reference Manual
screws (S05)
Disassembly and Assembly 9-19