MCM MODELS - BRAVO AND BLACKHAWK DRIVES
12. Support engine with suitable sling through lifting eyes on engine and remove front and
rear engine mounting bolts. Retain hardware.
13. Carefully remove engine. DO NOT hit power steering control valve.
Installation
Engine Installation/Alignment
1. Be certain fiber washers (cemented in place) on inner transom plate are present. Inspect
fiber washers. Replace if worn or damaged.
2. Install double wound lockwashers onto inner transom plate inside fiber washer.
3. Be certain rear engine mount locknuts are in position as shown.
4. Lubricate exhaust bellows with soap and water to ease installation.
5. Lubricate engine coupler splines with Quicksilver Engine Coupler Spline Grease.
Index
Index
Page 2A-4
Downloaded from
https://needmanual.com/
a -
Suitable Sling
b -
Engine Lifting Eyes
a
b
c
a -
Double Wound Lockwasher
b -
Fiber Wound Lockwasher (Cemented In Place)
c -
Inner Transom Plate Mount (Engine Support)
d -
Locknuts (Engine Mounting Bolts)
a
b
d
SERVICE MANUAL NUMBER 23
b
90-861326--1 MARCH 1999
75505
72023