Cr Encoder - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.4.7 CR ENCODER

When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1. Perform the Tube inner pressure reduction.
2. Remove the UPPER LEFT COVER.
3. Remove the UPPER SUPPORT R COVER.
4. Remove the PANEL BOARD. (p120)
5. Remove the TOP COVER. (p85)
6. Remove the FRONT COVER. (p86)
7. Remove the LEFT UPPER COVER & LEFT ROLL COVER.
8. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER.
9. Unlock the CR UNIT. (p83)
10. Remove the CR COVER. (p122)
11. Remove the DAMPER KIT. (p123)
12. Remove the PRINT HEAD. (p126)
13. Remove the RIGHT LOWER COVER.
14. Remove the APG UNIT. (p144)
15. Remove the CR MOTOR. (p141)
16. Remove the CR SCALE. (p135)
17. Remove the CR UNIT. (p156)
18. Remove the two screws, and remove the CR ENCODER.
A) Silver M2.6x8 Machine screw: 2 pcs
19. Disconnect the FFC from the connector of the CR ENCODER.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p248)
(p100)
(p94)
(p101)
(p95)
(p96)
Disassembly and Assembly Procedure
CR ENCODER
A A
Figure 3-82. Removing the CR ENCODER
Revision B
Connector
FFC
138
Confidential