Pump Cap Unit - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.4.13 PUMP CAP UNIT

When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1. Remove the UPPER LEFT COVER.
2. Remove the UPPER SUPPORT R COVER.
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER.
6. Remove the REAR RIGHT LOWER COVER.
7. Remove the RIGHT LOWER COVER.
8. Unlock the CR UNIT.(p83)
9. Move the CR UNIT on the Platen.
10. Remove the R Reinforce Plate.
11. Disconnect the cables from the Relay Connector (No.7, No.11, No.34).
12. Remove the three screws that secure the PUMP CAP UNIT.
A) Silver M3x8 S-tite screw with built-in washer: 3 pcs
In the next step, waste ink may spill from the Waste Ink Tube if the
C A U T I O N
tube is disconnected from the PUMP CAP UNIT. Prepare a waste
cloth or the like in advance and be careful not to contaminate the
surroundings.
13. Remove the Waste Ink Tube from the PUMP CAP UNIT.
14. Remove the PUMP CAP UNIT in the direction of the arrow.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p100)
(p94)
(p95)
(p99)
(p96)
(p144)
Disassembly and Assembly Procedure
Upper side
A
A
A
Waste Ink
Tube
PUMP CAP UNIT
Figure 3-95. Removing the PUMP CAP UNIT
Revision B
PUMP CAP UNIT
PUMP CAP UNIT
Relay Connector
(No.7, No.11, No.34)
A
147
Confidential