Removing The Sensors; Cr Encoder; Pf Encoder - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.6 Removing the Sensors

4.6.1 CR Encoder

1. Remove the Carriage Shaft / Carriage Unit. (p.88)
2. Remove the two C.B.P. M2.6 x 5 screws that secure the CR Encoder Sensor
Board.
3. Disconnect the PW Sensor FFC from the connector on the CR Encoder Sensor
Board, and remove the CR Encoder Sensor Board.
13) C.B.P. M2.6x5
(2±0.5 kgf.cm)
CR Encoder
Sensor Board
Figure 4-156. Removing the CR Encoder Sensor Board
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
PW Sensor FFC
Connector
Removing the Sensors

4.6.2 PF Encoder

1. Remove the Upper Housing / Printer Cover. (p.72)
2. Disconnect the FFC from the PF Encoder Sensor Board.
3. Remove the C.B.S. M3 x 8 screw that secures the PF Encoder Sensor Holder.
FFC
Connector
Figure 4-157. Removing the FFC and the Screw that Secures
the PF Encoder Sensor Holder
打印机驱动下载 http://www.printerwhy.com/
Revision A
PF Encoder Sensor Holder
5) C.B.S. M3x8
(6±1 kgf.cm)
124
Confidential