SC-T7000 series/SC-T5000 series/SC-T3000 series
3.4.5 Paper Feed Mechanism
3.4.5.1 PF MOTOR
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1.
Remove the UPPER LEFT COVER.
2.
Remove the UPPER SUPPORT R COVER.
3.
Remove the PANEL BOARD.
(p120)
4.
Remove the TOP COVER.
(p85)
5.
Remove the FRONT COVER.
(p86)
6.
Remove the LEFT UPPER COVER & LEFT ROLL COVER.
7.
Remove the REAR LEFT LOWER COVER.
8.
Remove the LEFT LOWER COVER.
9.
Remove the Tension Spring.
10. Remove the two screws, and remove the PF Motor Mounting Plate.
A) Silver M4x8 S-tite screw with built-in washer: 2 pcs
Pay attention to the positioning point (See
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p100)
(p94)
(p101)
(p104)
(p98)
Figure
3-115).
Disassembly and Assembly Procedure
A
PF MOTOR
PF Motor
Mounting Plate
Positioning point
Figure 3-115. Removing the PF Motor Mounting Plate
Revision B
Tension Spring
A
Confidential
163