Epson SC-T7000 series Service Manual page 246

SC-T7000 series/SC-T5000 series/SC-T3000 series
<PG check>
7. Place the thickness gauge on the specified position as follows, and check PG at the
both left and right of the PRINT HEAD. If the result is NG, adjust PG carrying out
Step 8 and the following steps.
When moving the CR UNIT, make sure to do it by pulling the CR
C A U T I O N
TIMING BELT.
SC-T7000 Series
When measuring the left side of the Head
Figure 4-32. The measurement position for SC-T7000 Series
SC-T5000 Series
When measuring the left side of the Head
Figure 4-33. The measurement position for SC-T5000 Series
ADJUSTMENT
When measuring the right side of the Head
When measuring the right side of the Head
CR Related Adjustments
SC-T3000 Series
When measuring the left side of the Head
Figure 4-34. The measurement position for SC-T3000 Series
Revision B
When measuring the right side of the Head
246
Confidential