SC-T7000 series/SC-T5000 series/SC-T3000 series
3.4.4.2 DAMPER KIT
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1.
Perform the Tube inner pressure reduction.
2.
Remove the UPPER LEFT COVER.
3.
Remove the UPPER SUPPORT R COVER.
4.
Remove the PANEL BOARD.
(p120)
5.
Remove the TOP COVER.
(p85)
6.
Remove the FRONT COVER.
(p86)
7.
Remove the LEFT UPPER COVER & LEFT ROLL COVER.
8.
Remove the RIGHT UPPER COVER & RIGHT ROLL COVER.
9.
Unlock the CR UNIT.
(p83)
10. Remove the CR COVER.
(p122)
11. Remove the two screws, and remove the CR Rear Frame.
A) Silver M3x6 S-tite screw with built-in washer: 2 pcs
Pay attention to the positioning points (See below figure,
3-54).
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p248)
(p100)
(p94)
(p101)
(p95)
Figure
Disassembly and Assembly Procedure
Positioning point
A
Positioning point
Figure 3-54. Removing the CR Rear Frame
Revision B
CR Rear Frame
Positioning point
A
Positioning point
Rear Tube Guide
Confidential
123