L Waste Ink Cover Sensor - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.2.22 L WASTE INK COVER SENSOR

1. Remove the UPPER LEFT COVER.
2. Remove the UPPER SUPPORT R COVER.
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the FRONT COVER. (p86)
6. Remove the LEFT UPPER COVER & LEFT ROLL COVER.
7. Remove the REAR LEFT LOWER COVER.
8. Remove the LEFT LOWER COVER.
9. Remove the Lower Paper Guide (Left)
10. Remove the screw that secures the L WASTE INK COVER SENSOR.
A) Silver M1.7x6 Pan machine screw with S.W: 1 pcs
11. Pull out the cable from the groove of the Maintenance Box Holder.
12. Release the cable from the nine clamps.
13. Disconnect the cable from the connector (CN8) of the SUB-B BOARD.
DISASSEMBLY & ASSEMBLY
(p100)
(p94)
(p101)
(p104)
(p98)
(p87)
Disassembly and Assembly Procedure
SUB-B BOARD
Clamp
CN8
Figure 3-35. Removing the L WASTE INK COVER SENSOR
Revision B
Maintenance Box
Holder
L WASTE INK
COVER SENSOR
Clamp
Groove
Cable
Bottom side
A
Confidential
108