Pressure Roller Motor - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.5.6 PRESSURE ROLLER MOTOR

1. Remove the UPPER LEFT COVER.
2. Remove the UPPER SUPPORT R COVER.
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the FRONT COVER. (p86)
6. Remove the LEFT UPPER COVER & LEFT ROLL COVER.
7. Remove the REAR LEFT LOWER COVER.
8. Remove the LEFT LOWER COVER.
9. Remove the Rear Cover Cap while sliding in the direction of the arrow.
Pay attention to the positioning point (See
Figure 3-126. Removing the Rear Cover Cup
DISASSEMBLY & ASSEMBLY
(p100)
(p94)
(p101)
(p104)
(p98)
Figure 3-126).
Rear Cover Cap
Positioning point
L Roll Side Frame
Disassembly and Assembly Procedure
10. Remove the two Plastic washers, and remove the Combination gear 26, 12.8 and
Combination gear 18.4, 37.6.
11. Remove the two screws, and remove the PRESSURE ROLLER MOTOR.
A) Silver M2.6x4 machine screw: 2 pcs
PRESSURE ROLLER MOTOR
Combination gear 26, 12.8
Figure 3-127. Removing the Combination gear 26, 12.8 and Combination gear 18.4, 37.6
Revision B
Combination gear 18.4, 37.6
A
A
Plastic washers
Confidential
171