Epson SC-T7000 series Service Manual page 255

SC-T7000 series/SC-T5000 series/SC-T3000 series
DAMPER KIT
Figure 4-47. Correcting the Head Inclination
8. Tighten the three screws to secure the head holder. Tighten them in the order
shown below. D - E - F
9. Tighten the screw to secure the adjustment knob.
10. Tighten the three screws to secure the DAMPER KIT. (there is no particular order
to tighten them.)
11. Attach the CR COVER.
12. Print the pattern and see if the inclination is corrected. If not, repeat the procedure
until the pattern becomes normal.
13. When finished, click [Finish] and turn the printer OFF.
ADJUSTMENT
C H E C K
P O I N T
Adjustment knob
Plus direction
Minus direction
Head Related Checks and Adjustments
For which direction to turn the knob, see below.
Paper feed
When Cyan lines lie below
direction
Magenta lines, turn
clockwise
The lines move about one-dot's width when the knob is moved
by five or six notches.
Revision B
When Cyan lines lie above
Magenta lines, turn
counterclockwise
255
Confidential