SC-T7000 series/SC-T5000 series/SC-T3000 series
3.4.6 Cutter Mechanism
3.4.6.1 CUTTER UNIT
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1.
Remove the UPPER LEFT COVER.
2.
Remove the UPPER SUPPORT R COVER.
3.
Remove the FRONT COVER.
(p86)
4.
Remove the TOP COVER.
(p85)
5.
Remove the RIGHT UPPER COVER & RIGHT ROLL COVER.
6.
Remove the FRONT COVER.
(p86)
7.
Remove the LEFT UPPER COVER & LEFT ROLL COVER.
8.
Remove the LEFT LOWER COVER.
9.
Remove the RIGHT LOWER COVER.
10. Remove the FRONT LEFT LOWER COVER.
11. Remove the IH COVER.
(p89)
12. Remove the LOWER PAPER GUIDE B.
13. Remove the LOWER PAPER GUIDE.
14. Disconnect the sensor cable from the Relay Connector (No.27).
15. Release the sensor cable from the four clamps.
16. Remove the pieces of acetate tape, and release the sensor cable.
17. Release the sensor cable from the hook of the CR Spacer.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p100)
(p94)
(p95)
(p101)
(p98)
(p96)
(p103)
(p88)
(p87)
Disassembly and Assembly Procedure
CUTTER UNIT
Sensor cable
Hook
Acetate tape
Figure 3-143. Releasing the Sensor Cable
Revision B
CR Spacer
Clamp
Clamps
Relay Connector
(No.27)
181
Confidential