Replacing An Sbus Card; Figure 11-6 Removing A Double-Width Sbus Card - Sun Microsystems SPARCstation 5 Service Manual

Figure 11-6 Removing a Double-Width SBus Card

7. Remove the card extractor from the SBus card:
a. Bend one leg of the extractor slightly to the outside until the hook
b. Remove the other side of the extractor, which should come out easily
8. Place the faulty SBus card on an antistatic surface.
Do not confuse it with the replacement card.

11.1.2 Replacing an SBus Card

1. If required for your card, set the jumpers or switches on the
replacement card.
See the manual for your SBus product.
2. Push back the two card retainers on the SBus connector (if necessary).
See Figure 11-7.
System Board and Component Replacement
Card
extractors
clears the hole in the SBus card.
See Figure 11-3.
without bending.
11
11-5