Replacing An Sbus Card - Sun Microsystems Ultra 1 Series Service Manual

Figure 10–12 Removing an SBus Card from Slot 2
2. Grasp the SBus card at both corners, and pull it up to disconnect it from the
socket.
Caution - Avoid applying force to one end or one side of the board. It damages the
connector pins.
3. Slide the SBus card out of the back panel, and place it on an antistatic surface.
1. Place the SBus card on an antistatic surface.
2. If required, set the jumpers or switches on the card.
See your SBus product documentation.
3. Remove the SBus card extractor (if any).
System Board and Component Replacement
93