Fujitsu PRIMERGY RX600 S3 User Manual page 228

Chapter 7 Installing Internal Options
For Tape Drv DAT72 36GB internal
Connect the USB cable to the USB connector on the baseboard. For the location of the USB
connector, refer to "1.3.4 Baseboard" ( pg.28).
11
Install the upper processor air baffle.
Insert the latches on the sides of the baffle into the sides of the server, and then insert the notches
on the front side of the baffle into the front of the server to install the cover.
Install the cable through the sides of the baffle. At this time, make sure that the cable is not
pinched.
The notches of the air baffle are
inserted in the tabs on a front
side of the server.
12
Connect the cables which are removed in step 8 to the original positions.
228
Notches
"Situation seen
from the back"
Insert the latches into
the sides of the server.
The cable is passed sideward
of the air baffle.