Fujitsu PRIMERGY RX600 S3 User Manual page 131

3
Double-click a LAN device name under [Network adapters].
Names of the LAN devices are displayed as follows.
Onboard LAN (1000BASE-T)
PG-1862
PG-1882
PG-1892
4
Insert the driver disk created from the ServerStart CD-ROM into the server.
5
Click [Update Driver] in the [Driver] tab window.
The "Welcome to the Hardware Update Wizard" window appears.
6
Check [No, not this time] and click [Next].
7
Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
8
Click [Finish].
9
Click [Close] to close the properties window.
Installing the LAN Driver
Perform the following procedures on each [Ethernet controller] under [Other devices] in [Device
Manager].
1
Insert the driver disk created from the ServerStart CD-ROM into the server.
2
Double-click [Ethernet controller] under [Other devices].
The properties window for the Ethernet controller appears.
3
Click [Reinstall Driver] in the [General] tab window.
The [Welcome to the Hardware Update Wizard] window appears.
4
Check [No, not this time] and click [Next].
5
Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
6
Click [Finish].
7
Click [Close] to close the properties window.
table: LAN device name
LAN cards
Broadcom NetXtreme Gigabit Ethernet
Intel(R) PRO/1000 MT Dual Port Network Connection
Intel(R) PRO/1000 MF Server Adapter
Intel(R) PRO/1000 MT Server Adapter
PRIMERGY RX600 S3 User's Guide
LAN device name
4
131