Fujitsu PRIMERGY RX600 S3 User Manual page 120

Chapter 4 Manual OS Installation
3
Insert the Windows Server 2003 x64 CD-ROM.
Turn on the server and insert the Windows Server 2003 x64 CD-ROM immediately into the CD-
ROM drive. When the active area is specified on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
4
The [Windows Server 2003 x64 Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
5
Install the Drivers manually.
1. When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows,
including those for which you have a device
support disk from a mass storage device
manufacturer, press S.
2. When the "Please insert the disk labeled Manufacturer-supplied hardware support
disk into Drive A:" message appears, insert the driver disk created from the
ServerStart CD-ROM and press the [Enter] key.
The following message appears.
You have chosen to configure a SCSI Adapter for use with
Windows, using a device support disk provided by an
adapter manufacturer.
Select the SCSI Adapter you want from the following list,
or press ESC to return to the
previous screen.
3. Select following item and press the [Enter] key.
Mega RAID SCSI 320-2E RAID Controller Drive
4. When the following message appears, press the [S] key.
The driver you provided seems to be newer than the Win-
dows default driver.
Setup will load support for the following mass Storage
device(s):
Mega RAID SCSI 320-2E RAID Controller Driver
6
Follow the instructions from the setup program to continue the installation
procedure.
If a message indicating that the driver has not passed Windows Logo testing to verify its
compatibility with Windows appears, select [Yes] to continue the installation procedure.
120
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.