Installing Windows Server 2003 - Fujitsu PRIMERGY RX600 S3 User Manual

Chapter 4 Manual OS Installation
The installation of Windows Server 2003 x64 has completed.
Before Starting Operation
After OS installation, refer to "Chapter 5 Operations after OS Installation" ( pg.137) and perform the
necessary procedures.

4.2.2 Installing Windows Server 2003

For details on the OS settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003.
Some drivers are created from the ServerStart CD-ROM. For how to create driver disks, refer to
"4.1 Creating Driver Disks" ( pg.114).
2
Turned on the server and configure RAID. If you do not configure RAID,
proceed to step 3.
Turn on the server to display the following message and press the [Ctrl] + [H] key to start up
WebBIOS.
Press <Ctrl><H> for WebBIOS
The array system is configured by using WebBIOS. For more details, refer to "Onboard SCSI
RAID User's Guide".
Turn off the server after configuring the array system.
3
Insert the Windows Server 2003 CD-ROM.
Turn on the server and insert the Windows Server 2003 CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
4
The [Windows Server 2003 Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
122
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.