Chapter 3 Os Installation Using Serverstart; Guided Mode; Starting Up The Guided Mode - Fujitsu PRIMERGY RX600 S3 User Manual

Chapter 3 OS Installation Using ServerStart

3.1 Guided Mode

In guided mode, follow the wizard to specify hardware configuration and the OS to be
installed, save the information necessary for installation in a configuration file, and
install the OS.

3.1.1 Starting Up the Guided Mode

Start up the guided mode.
Confirm that the floppy disk drive for USB connection has been connected before turning on the
server.
1
Turn on the server and insert the ServerStart Disc 1 CD-ROM immediately.
ServerStart starts up and a message prompts you to insert the ServerStart floppy disk.
2
Insert the ServerStart floppy disk supplied with the server. Make sure that
"Removable media" and "A:" are selected and click [Create].
60
Set the ServerStart floppy disk in the write-enabled state.
Select [No status backup / Keine Statussicherung] to install the OS other than Windows Server
2003 x64 on the server without the floppy disk drive. If the OS is installed without the floppy
disk, the RAID cannot be configured with ServerStart. Configure the RAID manually before
starting ServerStart.