Starting Manual Installation; Installing Windows Server 2003 X64 - Fujitsu PRIMERGY RX600 S3 User Manual

4.2 Starting Manual Installation

This section explains the procedures for installing the OS manually.
Confirm that the floppy disk drive for USB connection has been connected before turning on the
server.
USB Floppy Disk Drive
It is strongly recommended that only products listed on the following website are connected to the
server.
PRIMERGY website (http://primergy.fujitsu.com)
The Microsoft package products shipped after July 2003 are already applied to Service Pack 4 as well
as the volume-licensed Windows 2000 Server CD-ROM. However, the volume license also provides
Windows 2000 Server CD-ROM not applied to Service Pack 4.
You can confirm whether Service Pack 4 or later is applied using the label of your Windows 2000
Server CD-ROM.

4.2.1 Installing Windows Server 2003 x64

For details on the OS settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003 x64.
For how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.114).
2
Turned on the server and configure RAID. If you do not configure RAID,
proceed to step 3.
Turn on the server to display the following message and press the [Ctrl] + [H] key to start up
WebBIOS.
Press <Ctrl><H> for WebBIOS
The array system is configured by using WebBIOS. For more details, refer to "Onboard SCSI
RAID User's Guide".
Turn off the server after configuring the array system.
PRIMERGY RX600 S3 User's Guide
4
119