Fujitsu PRIMERGY RX600 S3 User Manual page 112

Chapter 3 OS Installation Using ServerStart
4
Specify "SerStartBatch.ini" on drive A and click [Create].
The display returns to the preparation mode window.
For procedures from setting wizards to completion of installation, refer to "3.2 Preparation
Mode" ( pg.77).
When performing remote installation, refer to "3.4 Remote Installation" ( pg.90).
Settings values in wizards
112
Setting items in wizards are set to the values set on the first server. For installation on subse-
quent servers, you must change the following items in the "OS installation wizard". For other
items, change the settings as necessary. You do not need to start up wizards where no settings
will be changed.
table: Settings to be Changed for Installation on Subsequent Servers
Window
Setting item name
name
User Computer name
Information
Product ID/CD key
Network IP address
Protocol
If the settings for the first server are not reflected to wizards, perform the procedures from
copying the floppy disk over again.
Remarks
The setting must be changed when the second
and subsequent servers are on the same
network as the first server.
The setting must be changed.
The setting must be changed when the second
and subsequent servers are on the same
network as the first server.