Fujitsu PRIMERGY RX600 S3 User Manual page 107

Hide thumbs Also See for PRIMERGY RX600 S3:
Table of Contents

Advertisement

3
Click [Click here to prepare and/or initiate an operating system installation].
The [Select the operating system to be installed] window appears.
Click [Special Hints on Operating System Installation] and read the contents. Important
information such as limitations on disk configuration is described.
4
Click [MS Windows Operating Systems].
The [Install Microsoft Windows Operating System Installation] window appears.
5
Select the OS to install and the mode.
6
Set items in wizards and save the configuration file.
For settings in wizards, refer to "3.1 Guided Mode" ( pg.60) or "3.3 Expert Mode" ( pg.83).
Set items in wizards and save the configuration file. When using the remote floppy, specify the
path to the shared folder for the remote floppy as the configuration file saving location.
Specify the shared name of the prepared shared folder instead of the local CD-ROM as instal-
lation source information.
7
Click [Click here, to Start the Installation of (OS)].
Installation starts. At steps where the CD-ROM for resources such as the OS to be installed is
necessary, the resource is automatically acquired from the resource server via the network.
8
Eject the CD-ROM and floppy disk and click [OK].
The system restarts. When the installation is completed, an installation completion message
appears on the target server.
9
Press any key on the target server.
10
Restart the system on the target server.
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" ( pg.137) and perform necessary procedures
before starting server operations.
In Preparation Mode
1
Create a configuration file.
For the creation procedure, refer to "3.2 Preparation Mode" ( pg.77).
Specify the shared name of the prepared shared folder instead of the local CD-ROM as instal-
lation source information.
2
Turn on the server and insert the ServerStart Disc 1 CD-ROM immediately.
ServerStart starts up and a message prompts you to insert the ServerStart floppy disk.
PRIMERGY RX600 S3 User's Guide
3
107

Advertisement

Table of Contents
loading

Table of Contents