Enabling The Rf Receiver For Wireless Communication; Setting Up A Zone For An Rf Device - Bosch AMAX 2100 Quick Start Manual

12 en | Programming and Operating the AMAX System
9.
10. Press [#] to save the data end exit the programming mode.
P
5.4.3

Enabling the RF Receiver for Wireless Communication

1.
2.
3.
4.
5.
6.
7.
8.
P
5.4.4

Setting up a Zone for an RF Device

1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Enter the number of the area you want to assign to this zone and press [#].
11. Enter the RF ID manually (9 digits).
12. Press [#] to confirm.
13. Press [–] four times to get to the EXIT PROG. +SAVE menu.
14. Press [#] to save the data end exit the programming mode.
P
2014.11 | 02 | F.01U.309.297
The system displays the next menu item: ZONE IN AREA. There is no need to proceed to
the following menu items for deleting a zone.
Press [–] four times to get to the EXIT PROG. +SAVE menu.
The selected zone is deleted (example: zone 1 is deleted).
Enter the installer code [1234] + [958] and press [#].
Select 7 RF MANAGER and press [#].
Select RF SETTING and press [#].
Select RF RECEIVER and press [#].
Select 1-enable and press [#].
Press [#] to confirm.
Press [–] three times to get to the EXIT PROG. +SAVE menu.
Press [#] to save the data end exit the programming mode.
The RF receiver for wireless communication is enabled.
Enter the installer code [1234] + [958] and press [#].
Select 3 ZONE MANAGER and press [#].
Select ADD/DELETE ZONES and press [#].
The system displays the next menu item: INPUT ZONE No.
Enter the number of the zone to which you to assign the RF device and press [#].
The system displays the next menu item: ZONE NAME INPUT.
Optionally enter a name for the zone. Therefore, the numbers on the text keypad function
as an alphabetical input.
Press [#] to confirm.
The system displays the next menu item: ZONE MODULE SEL.
Select the correct zone module depending on the RF device:
For RFUN / RF3401E (Zone input only) select 5-RF RFUN no magn
For RFGB / RF1100E (Glass Break Detector) select 4-RF RFGB glassb.
For all other RF devices (Zone input only) select 3-RF all
Press [#] to select and [#] again to confirm.
The system displays the next menu item: ZONE FUNCTION.
Enter 01 for the zone function 01-instant and press [#].
The system displays the next menu item: ZONE IN AREA.
The system displays the next menu item: ZONE RFID: MANUAL.
Or
Press and hold [*] for three seconds to switch to the ZONE RFID: AUTO menu.
Trigger the RF device to give alarm once.
The RF ID will be entered automatically.
The selected zone is set up for an RF device.
Quick Start Manual
AMAX 2100 / 3000 / 4000
Bosch Sicherheitsysteme GmbH