Front Seat Belt - Isuzu 1999 RODEO Workshop Manual

SEAT BELT SYSTEM
9A–2
Front Seat Belt and Associated Parts
Legend
(1) Door Seal Finisher (Front & Rear)
(2) Adjustable Shoulder Anchor Assembly
(3) Seat Belt Upper Anchor Bolt
(4) Center Pillar Upper Trim Cover
(5) Front Seat Belt Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the sill plate (Front & Rear).
3. Remove the seat belt lower anchor bolt.
4. Remove the center pillar lower trim cover.
5. Remove the door seal finisher (Front & Rear).
6. Remove the center pillar upper trim cover.
7. Remove the seat belt upper anchor bolt.
8. Remove the retractor.
9. Remove the adjustable shoulder anchor assembly.

Front Seat Belt

(6) Seat Belt Lower Anchor Bolt
(7) Center Pillar Lower Trim Cover
(8) Retractor
(9) Rear Sill Plate
(10) Front Sill Plate
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the adjustable shoulder anchor assembly
fixing bolts to the specified torque.
Torque: 39 N·m (29 lb ft)
2. Tighten the seat belt anchor bolts (Upper & Lower)
and the retractor fixing bolts to the specified torque.
Torque: 39 N·m (29 lb ft)
760RW040