Removing A Cpu Module - Sun Microsystems Sun Blade 1000 Cpu Module Installation Instructions

Removing a CPU Module

1. If necessary, place the workstation on its side on a work surface, open side facing
up (see ).
FIGURE 6
2. Remove torque tool A or torque tool B from its holder.
Note – Sun manufacturing installs torque tool A or torque tool B in Sun Blade 1000
workstations. The torque tools are located in different locations in the workstation
(see ).
FIGURE 6
3. If necessary, remove the filler panel (see
Squeeze the two tabs on the filler panel to release it from the cover for the CPU
shroud.
Removing the Filler Panel
FIGURE 7
FIGURE 7
Tab (2)
Sun Blade 1000 UltraSPARC III CPU Module Installation Instructions
).
Filler panel
Cover for the CPU shroud
CPU shroud
15