Operation Of Diagnostic Commander - Konica Minolta Magicolor 3300 Service Manual

2.3 Operation of Diagnostic Commander

2.3.1 Starting Diagnostic Commander
[Steps]
1) Turn on the power switch of the printer.
2) Start the Windows, and double-click the shortcut icon [Hibana Service Commander.] on the desktop.
3) To exit the Diagnostic Commander, click the Close button.
2.3.2 Description of initial screen
When the Diagnostic Commander started, the screen shown below appears.
This screen displays the printer conditions, and the versions of printer and NVM. Clicking the buttons on
this screen allows various diagnostics to be executed.
The windows that show the printer conditions are as follows.
Window name
Current operation mode is displayed.
Mode For the modes, refer to "6.2 Operation Modes in Section 6
Operational Principle".
The contents of errors in the ERROR mode are displayed.
If any error is displayed here, the printer cannot perform printing
Call
operation.
For the errors, refer to "Section 1 Troubleshooting".
The errors related to the lifetime in the ERROR mode are displayed.
The printer can perform printing operation, if no error is displayed in
Life Over
the Call window but errors are displayed only in this window.
For the errors, refer to "Section 1 Troubleshooting".
Warnings for the printer are displayed.
Warning
For the errors, refer to "Section 1 Troubleshooting".
Description
Chapter 2 Operation of Diagnostics
2-121