Konica Minolta Magicolor 3300 Service Manual page 132

2.7.4 Write NVM Data
The data described in already prepared text file are written to the NVM. In the text file, a pair of address and
data is described, same as in the file created in "2.7.3 Save NVM Data", and the data are written only to the
addresses described in the file. (.TXT extension)
If the printer version is updated, the NVM initial values may have to be changed. In
such a case, rewrite the NVM data using this function.
[Steps]
1) Click the [Write NVM Data] button, and the following screen will appear.
2) The text file NVM data to write in is described to be is chosen.
A text file is saving at the temp folder under the folder which installed the Diagnostic
Commander.
3) Click the [Open] button.
4) Upon completion of writing, the message is displayed.
Successful termination: completed.
Unsuccessful termination:Write - in operation of a nenvolatile memory was not completed normally.
Reference: The contents of text file are written to the NVM sequentially, but if there is an address
where data can't be written, the operation is terminated unsuccessfully and the subse-
quent file data are not written. You can confirm where unsuccessful termination
occurred by referring to the data transmission/receiving records in the communication
log file.
2-132