Konica Minolta Magicolor 3300 Service Manual page 165

Removal
1) Release the latch at A from the printer and open the CHUTE ASSY IN (PL5.1.1) together with the
CHUTE ASSY OUT (PL6.1.1).
2) Remove 2 screws securing the COVER ASSY FRONT IN to the CHUTE ASSY IN.
3) Release the latch at B from the printer and open the CHUTE ASSY OUT.
In the following process, do not separate the COVER ASSY FRONT IN and LINK:R too
far since they are connected.
4) Pull out the COVER ASSY FRONT IN slightly from the CHUTE ASSY IN.
5) Shift the boss at the end of the LINK:R from the leaf spring at the back of the COVER ASSY FRONT IN
and remove the COVER ASSY FRONT IN.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-165