Removal
1)
Release the latch at A from the printer and open the CHUTE ASSY IN (PL5.1.1).
2)
Remove the BTR UNIT ASSY. (RRP8.4)
3)
Release the hooks at 4 positions securing the SENSOR ADC ASSY to the CHUTE ASSY IN of the
printer.
4)
Raise the SENSOR ADC ASSY slightly from the CHUTE ASSY IN and pull out the connector
(P/J136).
5)
Remove the SENSOR ADC ASSY from the CHUTE ASSY IN together with the SPRING ADC
(PL5.1.12).
6)
Remove the SPRING ADC from the SENSOR ADC ASSY.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-237