Konica Minolta Magicolor 3300 Service Manual page 351

Removal
1) Remove the COVER TOP MAIN. (RRP1.4)
2) Remove the COVER ASSY FRONT IN. (RRP1.10)
3) Remove the COVER SIDE R. (RRP1.9)
4) Remove 1 screw securing the earth of the HARNESS ASSY AC SW to the LVPS (PL12.1.10) from the
printer.
5) From the printer, release the hooks at 2 positions securing the GUIDE HARNESS SW to the switch
bracket on the LVPS and shift the GUIDE HARNESS SW upward.
6) Shift the switch of the HARNESS ASSY AC SW from the switch bracket of the LVPS.
7) Remove the connector (P/J161) on the LVPS.
8) Releasing the hooks at 2 positions securing the socket of the HARNESS ASSY AC SW to the rear of
the LVPS and pull out the socket rearward.
9) Remove the HARNESS ASSY AC SW from the printer.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-351