Konica Minolta Magicolor 3300 Service Manual page 339

Removal
1) Remove the COVER TOP MAIN. (RRP1.4)
2) Remove the COVER ASSY FRONT IN. (RRP1.10)
3) Remove the COVER SIDE R. (RRP1.9)
4) Remove the LINK:R. (RRP1.8)
5) Remove the connector (P/J48) on the PWBA DRV HBN (PL12.1.12) from the right side surface of the
printer.
6) Remove the connector (P/J52) on the PWBA DRV HBN.
7) Disconnect the connector (P/J50) on the PWBA DRV HBN.
8) Remove the screw securing the WIRE ASSY FSR EARTH (PL5.1.20) to the MAIN DRIVE ASSY at the
right side of the Main Frame.
9) Remove 4 screws securing the MAIN DRIVE ASSY to the printer.
10) Remove the MAIN DRIVE ASSY from the printer.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-339