Preparation - Konica Minolta Magicolor 3300 Service Manual

2.2 Preparation

2.2.1 Supported configurations/platforms
The magicolor 3300 Diagnostics (Hibana Service Commander) program requires the following
configurations/platforms:
Items
CPU
Memory
Display
OS
Communication port
2.2.2 Installing magicolor 3300 Diagnostics (Hibana Service Commander)
[Steps]
1) Start Windows.
2) Insert the magicolor 3300 Computer-Based Training CD-ROM (which includes the magicolor 3300
Diagnostics [Hibana Service Commander] program) into your PC's CD-ROM drive.
3) After the CBT autoboots, close it.
4) From the [Start] menu choose [Run].
In the Run dialog box, type x:\commander\setup.exe" (where x is the letter of your CD-ROM drive), and
5)
click the [OK] button.
6) Follow the instructions on the screen to complete the installation.
2.2.3 Uninstalling magicolor 3300 Diagnostics (Hibana Service Commander)
[Steps]
1) Start Windows.
2) From the [Start] menu choose [Settings], then choose [Control Panel].
2) In the Control Panel window, double-click the [Add or Remove Programs] icon.
3) In the Add or Remove Programs window, select Hibana Service Tool, and then click the [Change/
Remove] button.
4) Follow the instructions on the screen to complete the uninstallation.
5) Close the Add or Remove Programs window and the Control Panel window.
2.2.4 Connecting diagnostic tools
[Steps]
1) Remove the CONTROLLER BOARD. (See RRP12.3)
2) Connect the DIAG PWB to the interface connector (P14) of the PWBA MCU HBN.
3) Connect the DIAG PWB to the PC with the RS-232C cable.
The RS-232C cable used must be compatible with the DIP SW (cross/straight) setting
and the connector of the DIAG PWB, and also it must be shielded properly and less
than 6 ft (2 m) in length.
2-120
Pentium 90 MHz (166 M Hz or higher preferable)
48 MB (64 MB preferable)
VGA (640 × 480)
Windows XP/2000/Me/98/95/NT
RS-232C interface furnished
Description