Konica Minolta Magicolor 3300 Service Manual page 153

Removal
Before removing the COVER TOP MAIN, remove the cartridge in advance to avoid the
interference of it.
1) Remove the COVER TOP (PL1.1.8) from the printer.
2) Release the latch at B from the printer and open the CHUTE ASSY OUT (PL6.1.1).
3) Open the COVER ASSY TOP PHD (PL1.1.10) from the printer.
4) Remove 2 screws securing the COVER TOP MAIN (PL1.1.9) to the printer.
5) Release the hooks at 4 positions securing the rear of the COVER TOP MAIN to the printer.
6) Raise the COVER TOP MAIN slightly from the printer and extract the left front edge of the COVER
TOP MAIN deflecting it leftward.
7) Remove the COVER TOP MAIN from the printer.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-153