Konica Minolta Magicolor 3300 Service Manual page 273

Konica minolta magicolor 3300 laser printer service manual
Hide thumbs Also See for Magicolor 3300:
Table of Contents

Advertisement

Removal
1)
Remove the FUSER ASSY. (RRP8.1)
2)
Remove the COVER TOP MAIN. (RRP1.4)
3)
Remove the COVER ASSY FRONT HEAD. (RRP1.2)
4)
Remove the COVER MSI. (RRP1.11)
5)
Remove the TRAY ASSY BASE. (RRP1.12)
6)
Remove the COVER ASSY FRONT. (RRP1.13)
7)
Remove the COVER ASSY FRONT IN. (RRP1.10)
8)
Remove the CHUTE ASSY EXIT. (RRP7.1)
9)
Remove the COVER SIDE L. (RRP1.14)
10) Remove the COVER SIDE R. (RRP1.9)
11) Remove the STRAP. (RRP8.6)
12) Remove the CHUTE ASSY OUT. (RRP6.1)
13) Remove the SOLENOID FEED MSI. (RRP6.2)
14) Release a hook of the SPRING SOL 0.5 (PL6.1.39) from a convex portion on the STOPPER SOL
(PL6.1.38) from the CHUTE ASSY OUT.
15) Release the hook at 1 position securing the STOPPER SOL to the left shaft of SHAFT MSI, and pull
out the STOPPER SOL of the shaft from the CHUTE ASSY OUT.
16) Release the hook at 1 position securing the GEAR MSI (PL6.1.22) to the right shaft of SHAFT MSI,
and pull the GEAR MSI out of the shaft from the CHUTE ASSY OUT.
17) Release the hooks of the SPRING N/F MSI 250gf (PL6.1.21) from the left and right shafts of SHAFT
ASSY ROLL FEED from the CHUTE ASSY OUT.
18) Release the hook at 1 position securing the CAM MSI (PL6.1.25) to the SHAFT MSI (PL6.1.28), and
move the CAM MSI inside from the CHUTE ASSY OUT (PL6.1.1).
19) Pull off the BEARING MSI (PL6.1.24) on the SHAFT MSI toward the inside from the bearing of the
CHUTE ASSY OUT.
20) Raising the right end of the SHAFT ASSY ROLL FEED, pull out the SHAFT ASSY FEED from the
CHUTE ASSY OUT.
21) After removing the SHAFT ASSY FEED, be sure to replace the CAM MSI. Do not leave the hook of the
CAM MSI being raised.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-273

Advertisement

Table of Contents
loading

Table of Contents