Konica Minolta Magicolor 3300 Service Manual page 269

Removal
1) Remove the COVER ASSY FRONT HEAD. (RRP1.2)
2) Remove the COVER MSI. (RRP1.11)
3) Remove the TRAY ASSY BASE. (RRP1.12)
4) Remove the COVER ASSY FRONT. (RRP1.13)
5) Pushing down the PLATE ASSY BOTTOM MSI on the CHUTE ASSY OUT (PL6.1.1) from the printer,
push the actuator of the ACTUATOR MSI inward.
6) Slide the ACTUATOR MSI leftward from the CHUTE ASSY OUI and extract the shaft on the right side
of the ACTUATOR MSI.
7) Move the right shaft of the ACTUATOR MSI toward the front from the CHUTE ASSY OUT and extract
the ACTUATOR MSI together with the SPRING SENSOR MSI (PL6.1.36).
8) Remove the SPRING SENSOR MSI from the ACTUATOR MSI.
Replacement
Replace the components in the reverse order of removal.
Chapter 3 Removal and Replacement Procedures
3-269