Functions; Recording System; Exposure System; Development System - Konica Minolta Magicolor 3300 Service Manual

4. Functions

4.1 Recording System

OPC drum, 4-tandem cartridges, electro-photographic system using intermediate transfer rolls

4.2 Exposure System

Semiconductor laser, simultaneous scanning by 4 beams

4.3 Development System

Development with dry type 2-component developer

4.4 Fixing System

Heat fusing of the free belt nip system

4.5 Resolution

Two types of resolutions can be switched. Printing speed is halved at 1200dpi
Main scanning direction:600 dots/25.4mm (by video signal from controller)
1200 dots/25.4mm (by video signal from controller) (Half speed)
Sub scanning direction:600 dots/25.4mm (fixed)
1200 dots/25.4mm (fixed) (Half speed)

4.6 Operation Mode

The printer can be operated in either of 2 operation modes. The modes are switched over by command
from the printer controller or change of printer operation, etc.
Running mode
State in running or recording operation
Fixing system:
Exposure system:
Recording system:
Fuser fan:
Rear fan:
Ready mode
Ready state
Fixing system:
Exposure system:
Recording system:
Fuser fan:
Rear fan:
*1: It can be changed to ready temperature status by a command from a controller.
(However, it needs to be back in a stop status within 2 hours.)
*2: It can be changed to operating status by a command from a controller.
*3: Fan status is changed depending on the state (temperature, etc.) of the fixing system.
8-500
Held at operating temperature.
Operating status
Operating status
Operating at high speed
Operating at high speed
Stop status *1
Stop status *2
Stop status
Stop status *3 (Half speed running)
Stop status *3 (Half speed running)