Keithley 2001 Operator's Manual page 467
Multimeter
Hide thumbs
Also See for 2001:
- Operator's manual (488 pages) ,
- Repair manual (168 pages) ,
- Calibration manual (107 pages)
Table of Contents
Advertisement
Command
:SENSe2
:TTL[1]
:DATA?
:SOURce
:TTL[1][:LEVel] <b>
:TTL[1][:LEVel]?
:TTL2[:LEVel] <b>
:TTL2[:LEVel]?
:TTL3[:LEVel] <b>
:TTL3[:LEVel]?
:TTL4[:LEVel] <b>
:TTL4[:LEVel]?
:STATus
:MEASurement
[EVENt]?
:ENABle <NRf>
:ENABle?
:PTRansition <NRf>
:PTRansition?
:NTRansition <NRf>
:NTRansition?
:CONDition?
:QUEue
:DISable <list>
:DISable?
:CLEar
:SYSTem
:POSetup <name>
:POSetup?
:FRSWitch?
:AZERo
:TYPE <name>
:TYPE?
:STATe <b>
:STATe?
:AMEThod <name>
:AMEThod?
:LSYNc
:STATe <b>
:STATe?
:CLEar
2001-900-01 Rev. K / August 2010
Description
Path to read digital input port:
Query (read) the digital input port.
Set digital output line #1 true (1 or ON) or false (0 or OFF).
Query digital output line 1.
Set digital output line #2 true (1 or ON) or false (0 or OFF).
Query digital output line 2.
Set digital output line #3 true (1 or ON) or false (0 or OFF).
Query digital output line 3.
Set digital output line #4 true (1 or ON) or false (0 or OFF).
Query digital output line 4.
Path to control measurement event registers:
Read the event register.
Program the enable register.
Read the enable register.
Program the positive transition register.
Read the positive transition register.
Program the negative transition register.
Read the negative transition register.
Read the condition register.
Path to access error queue:
Specify messages not to be placed in queue.
Read the disabled messages.
Clears all messages from Error Queue.
Select power-on setup: RST, PRESet, SAV0-SAV9.
Query power-on setup.
Query INPUTS switch (0 = rear, 1 = front).
Path to set up auto-zero.
Select auto-zero mode: NORMal, SYNChronous.
Query auto-zero mode (0 or 1).
Enable (1 or ON) or disable (0 or OFF) auto-zero.
Query auto-zero (0 or 1).
Select reading acquisition method: BURSt, NORMal, ASTReam, SSTReam.
Query acquisition method.
Path to control line synchronization of measurements.
Enable (1 or ON) or disable (0 or OFF) line sync.
Query line sync (0 or 1).
Clears messages from the Error Queue.
SCPI Conformance Information
I-19
Advertisement
Table of Contents
