Keithley 2001 Operator's Manual page 300

IEEE-488 Reference
Parameters
Formats
Defaults
Query
Description
Programming example
4-142
[:STATe] <b>
[:SENSe[1]]:CURRent:AC:AVERage[:STATe] <b>Control filter for ACI
[:SENSe[1]]:CURRent[:DC]:AVERage[:STATe] <b>Control filter for DCI
[:SENSe[1]]:VOLTage:AC:AVERage[:STATe] <b>Control filter for ACV
[:SENSe[1]]:VOLTage[:DC]:AVERage[:STATe] <b>Control filter for DCV
[:SENSe[1]]:RESistance:AVERage[:STATe] <b>Control filter for 2
[:SENSe[1]]:FRESistance:AVERage[:STATe] <b>Control filter for 4
[:SENSe[1]]:TEMPerature:AVERage[:STATe] <b>Control filter for TEMP
<b> = 0 or OFF
= 1 or ON
:curr:ac:aver <b> :curr[:dc]:aver <b>
:volt:ac:aver <b>:volt[:dc]:aver <b>
:res:aver <b>:fres:aver <b>
:temp:aver <b>
Power-up
*RST
:SYSTem:PRESet
:STATe]? Query state of digital filter
Short-form format: :curr:ac:aver?
:volt:ac:aver?
:res:aver?
:temp:aver?
Response message: 0 (off) or 1 (on)
These commands are used to enable or disable the digital averaging filter for the specified func-
tion. When enabled, readings will be filtered according to how the filter is configured.
10 OUTPUT 716; ":curr:ac:aver on; aver?"
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10 Enables the filter, and then queries the state of the filter.
Line 20 Addresses the Model 2001 to talk.
Line 30 Displays the state of the filter (1; on).
Disable the digital filter
Enable the digital filter
Saved power-on setup
OFF (all functions)
OFF (ACI, ACV and TEMP)
ON (DCI, DCV, 2 and 4)
:curr[:dc]:aver?
:volt[:dc]:aver?
:fres:aver?
2001-900-01 Rev. K / August 2010