Rjunctionx - Keithley 2001 Operator's Manual

Format
Defaults
Query
Description
Programming example

4.19.22 :RJUNctionX

Parameter
Description
Parameters
Format
Defaults
Query
2001-900-01 Rev. K / August 2010
= B
= N
:temp:tc:type <name>
Power-up
*RST
:SYSTem:PRESet
:TYPE? Query thermocouple type
Short-form format: :temp:tc:type?
Response message: J, T, K, E, R, S, B, or N
This command is used to configure the Model 2001 for the thermocouple type that you are using to make
temperature measurements.
10 OUTPUT 716; ":temp:tc:type k; type?"
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10 Two commands in this program message; the first configures operation for Type K thermo-
couples, and the second queries the thermocouple type.
Line 20 Addresses the Model 2001 to talk.
Line 30 Displays the thermocouple type (K).
[:SENSe[1]]:TEMPerature:RJUNctionX
X= 1 to 5
Used to configure the specified reference junction for thermocouple temperature measurements.
Typically, each thermocouple switching card uses a single reference junction.
:RSELect <name>
[:SENSe[1]]:TEMPerature:RJUNctionX:RSELect <name>Specify reference junction type
<name> = SIMulated
= REAL
:temp:rjunX:rsel <name>
where; X = 1 to 5 (reference junction #)
Power-up
*RST
:SYSTem:PRESet
:RSELect? Query reference junction type
Short-form format: :temp:rjunX:rsel?
Set operation for Type B thermocouples
Set operation for Type N thermocouples
Saved power-on setup
Type J
Type J
Specify reference junction
Use simulated temperature as reference
Use a measured temperature as reference
Saved power-on setup
SIMulated
SIMulated
IEEE-488 Reference
4-157