Keithley 2001 Operator's Manual page 238
Multimeter
Hide thumbs
Also See for 2001:
- Operator's manual (488 pages) ,
- Repair manual (168 pages) ,
- Calibration manual (107 pages)
Table of Contents
Advertisement
IEEE-488 Reference
Format
Description
Programming example
Parameters
Format
Query
Description
Programming example
Parameters
Format
Defaults
4-80
:disp:cnd
This action command is used to clear the bottom display of NEXT (or PREV) messages and can-
cel the operations associated with them. This command has no effect on any other message
types.
This programming example assumes that a NEXT operation is currently being displayed.
OUTPUT 716; ":cnd"
:SMESsage <b>
:DISPlay:SMESsage <b>
<b>
= 0 or OFF
= 1 or ON
:disp:smes <b>
Power-up
*RST
:SYSTem:PRESet
:SMESsage?
Query state of status message mode
Short-form format:
:disp:smes?
Response message:
1 (on) or 0 (off)
This command is used to enable/disable the status message mode for the Model 2001. The status
message mode is a diagnostic tool that provides real-time messages that relate to the current op-
erating state of the instrument. See
10 OUTPUT 716; ":disp:smes on; smes?"
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10
Enables the status message mode, and then queries the state of the message mode.
Line 20
Addresses the Model 2001 to talk.
Line 30
Displays the state of the status message mode (1; on).
:ENABle <b>
:DISPlay:ENABle <b>
<b>
= 0 or OFF
= 1 or ON
:disp:enab <b>
Power-up
! Clears NEXT display.
Control status message
Disable status messages
Enable status messages
Saved power-on setup
OFF
OFF
Table 3-4
for a list of status messages.
Control display circuitry
Disable display circuitry
Enable display circuitry
ON
2001-900-01 Rev. K / August 2010
Advertisement
Table of Contents
