Igmp Snooping Mrouter-Time-Out; Igmp Snooping Prejoin - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Multicast)
Syntax
Description
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Related
Commands
Purpose
Command Modes
Syntax
60 Confidential and Proprietary Information of ZTE CORPORATION
interface <port-na
me>
version <1-3>
master <1-99>
slave<1-99>
The interface configured by this command is not aging. Config-
ure acl rule before configuring route interface master/slave acl.
Open route interface master/slave function when configuring mas-
ter/slave acl.
igmp snooping static
igmp snooping
mrouter-time-out
Use this command to set the aging time of the multicast routing
interface in a VLAN. Note that this command takes no effect on the
interface in static configuration mode. Restore default with the no
form of this command.
VLAN configuration
igmp snooping mrouter-time-out <time>
no igmp snooping mrouter-time-out
<time>
igmp snooping host-time-out

igmp snooping prejoin

Use this command to configure the group pre-join function of IGMP
SNOOPING.
VLAN configuration
igmp snooping prejoin <ip-address>[num <number>]
no igmp snooping prejoin <ip-address>[num <number>]
Port name
Configured route interface version
Master ACL number of route interface
Slave ACL number of route interface
Aging time of the multicast routing interface
in seconds, range: 30~65535, default: 260
seconds