Spt-Threshold; Static-Rp - Zte ZXR10 8900 Series Command Reference Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
show ip route

spt-threshold

Use this command to configure the router with directly-connected
receivers to change from the SPT tree to the shared tree, RP tree.
Disable this feature with the no form of this command.
Router configuration
spt-threshold infinity [group-list <access-list-number>] no
spt-threshold infinity [group-list <access-list-number>]
infinity
group-list
<access-list-number>
By default, the threshold for changing from the shared tree to the
source shortest path tree (SPT) is 0.
If no <access-list-number> is specified, all the multicast group
addresses stay at the RP tree.
access-list

static-rp

Use this command to configure the static RP address. Delete the
static RP address with the no command.
Router configuration
static-rp <ip-address>[group-list <access-list-number>][prior
ity <priority>]
no static-rp
<ip-address>
group-list
<access-list-number>
<priority>
There is no static RP set by default.
1. After the static RP is configured, it will enter the RP set to
participate the selection, even if this router does not receive
any advertisement of RP information of BSR .
2. If no <access-list-number> is specified, the static RP applies
for all multicast groups.
Confidential and Proprietary Information of ZTE CORPORATION
Infinity, makes all sources of the specified
group use the shared tree
Standard IP access list number, range: 1~99
Static RP address in the dotted decimal format
Standard IP access list number, range: 1~99
Priority, range: 0~255, default: 192
Chapter 3 PIM-SM Protocol
37