Ip Msdp Redistribute; Ip Msdp Sa-Filter In - Zte ZXR10 8900 Series Command Reference Manual
10 gigabit routing switch
Hide thumbs
Also See for ZXR10 8900 Series:
- User manual (186 pages) ,
- Command manual (177 pages) ,
- Command reference manual (147 pages)
Table of Contents
Advertisement
ZXR10 8900 Series Command Reference (Multicast)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
48
Confidential and Proprietary Information of ZTE CORPORATION
ip msdp default-peer
ip msdp redistribute
Use this command to configure which (S, G) entries from the multi-
cast routing table are advertised in Source-Active (SA) messages
originated to Multicast Source Discovery Protocol (MSDP) peers.
Cancel the setting with the no form of this command.
Global configuration
ip msdp redistribute [list <acl-number>]
no ip msdp redistribute
list <acl-number>
1. If this command is not configured, local sources are advertised
only when the MSDP speaker is a multicast group rendezvous
point (RP) accepting local sources. If this command is config-
ured:
i. If list <acl-number> is specified, only the (S, G) multicast
route entries matching ACL rules appear in SA messages.
ii.
If there is no list <acl-number> specified, no multicast
sources are advertised.
2. This command affects SA message origination, not SA mes-
sage forwarding. If you want to filter which SA messages are
forwarded to MSDP peers, use the ip msdp sa-filter in or ip
msdp sa-filter out command
This example describes how to configure the router to advertise
only the (S, G) multicast route entries with the source address
1.1.1.0/24 and the group address 224.1.0.0/16.
ZXR10(config)#ip access-list extended 100
ZXR10(config-ext-nacl)#permit ip 1.1.1.0 0.0.0.255 224.1.0.0
0.0.255.255
ZXR10(config)#ip msdp redistribute list 100
ip msdp sa-filter in
ip msdp sa-filter out
ip msdp sa-filter in
Use this command to configure an incoming filter list for Source-
Active (SA) messages received from the specified Multicast Source
Discovery Protocol (MSDP) peer. Cancel the setting with the no
form of this command.
Global configuration
ip msdp sa-filter in <peer-address>[list <acl-number>]
Extended ACL number, range: 100~199
Advertisement
Table of Contents
