ZXR10 8900 Series Command Reference (Multicast)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
Related
Commands
Purpose
24
Confidential and Proprietary Information of ZTE CORPORATION
This example describes how to prevent the router defined by ACL
10 from participating in Protocol Independent Multicast (PIM) on
the interface fei_1/1.
ZXR10(config)#access-list 10 deny 10.1.1.1 0.0.0.0
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip pim neighbor-filter 10
show ip pimsm neighbor
ip pim query-interval
Use this command to configure the frequency of Protocol Indepen-
dent Multicast (PIM) router query messages. Restore default with
the no form of this command.
Interface configuration
ip pim query-interval <seconds>
no ip pim query-interval
<seconds>
show ip pimsm interface
ip pim sm
Use this command to enable PIM-SM protocol on the interface.
Disable PIM-SM protocol on the interface with the no form of this
command.
Interface configuration
ip pim sm
no ip pim sm
The multicast routing protocol PIM-SM is disabled on the interface
by default.
When the multicast routing protocol PIM-SM is enabled on the in-
terface, IGMP is automatically started on the interface.
show ip pimsm interface
ip mroute
Use this command to establish static multicast routes.
static multicast routes with no form of this command.
Specifies the interval, in seconds, at which
periodic PIM hello messages are sent, range:
1~65535, default: 30 seconds
Delete