ZXR10 8900 Series Command Reference (Multicast)
Related
Commands
Command
Function
Command Modes
Command format
Related
Commands
Purpose
Command Modes
Syntax
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
22
Confidential and Proprietary Information of ZTE CORPORATION
show ip mroute
ip multicast-loadshare
This command is used to enable L3 multicast load sharing function.
Global configuration mode
ip multicast-loadshare
no ip multicast-loadshare
ip multicast-routing
router pimsm
ip multicast-routing
Use this command to enable IP multicast routing. Disable IP mul-
ticast routing with the no form of this command.
Global configuration
ip multicast-routing
no ip multicast-routing
After IP multicast routing is disabled, the router does not forward
any multicast packet, and the multicast routing protocol stops run-
ning at the same time.
router pimsm
ip pim bsr-border
Use this command to prevent bootstrap router (BSR) messages
from being sent or received through an interface. Disable this
configuration with the no form of this command.
Interface configuration
ip pim bsr-border
no ip pim bsr-border
This command is disabled by default.
When this command is configured on an interface, no PIM BSR
messages will be sent or received through the interface. Configure
an interface bordering another PIM domain with this command to
avoid BSR messages from being exchanged between the two do-
mains.